Awkward customer 5 Posted September 24, 2010 Since I was banded I have only swum in my leisure centre and not used the gym part. That's because I am worried about using an abs crunch with the band. something like this: You kind of bend over the bar, and it trains your abs. Would this be a risk for ripping the stitches? Note I am 7 months from my op. Share this post Link to post Share on other sites
Laura Lane 0 Posted September 24, 2010 seven months out, mmm i don't think there should be a problem....:biggrin: Share this post Link to post Share on other sites
trishfish 1 Posted September 24, 2010 there is no ab workout more intense than the p90x ab routine, and i do it just fine! This should be no problem at all for you :biggrin: Share this post Link to post Share on other sites
zeniada 9 Posted September 24, 2010 At 7 months wouldn't your stiches be healed already??? Share this post Link to post Share on other sites
Awkward customer 5 Posted September 24, 2010 At 7 months wouldn't your stiches be healed already??? I suppose it - I was thinking i could still rip it all apart by accident. Share this post Link to post Share on other sites
Melissannde 41 Posted September 24, 2010 Do you need to use a machine? Can you lie down on the floor and do regular crunches? I do understand that some folks have trouble getting on the floor.. I've been there myself and still have issues when my knee is hurting.. I'd think at 7 months out you'd be OK for crunches.. start gentle and at low weights and work your way up slowly. You could always consult your physician or ask a trainer who is familiar with banded folks. Share this post Link to post Share on other sites
BetsyB 9 Posted September 24, 2010 I was cleared to use this machine (and do all exercise, without restriction) after my 4-week check. Share this post Link to post Share on other sites
Noturningback15 45 Posted September 24, 2010 I just hit 7 months out myself and was wondering the same thing. I keep passing by that machine at the gym but I just look! I am terrified my port will move or something!! Share this post Link to post Share on other sites